9/23/2023 0 Comments Debian ifconfig inet6![]() ![]() Media type Set the physical port or medium type to be used by the device. Mem_start addr Set the start address for shared memory used by this device. Io_addr addr Set the start address in I/O space for this device. Not all devices can dynamically change their IRQ setting. Irq addr Set the interrupt line used by this device. Tunnel ::aa.bb.cc.dd Create a new SIT (IPv6-in-IPv4) device, tunnelling to the given destination. This value defaults to the usual class A, B or C network mask (as derived from the interface IP address), butĪdd addr/prefixlen Add an IPv6 address to an interface.ĭel addr/prefixlen Remove an IPv6 address from an interface. Netmask addr Set the IP network mask for this interface. This keyword is now obsolete use the pointopoint keyword instead. Mtu N This parameter sets the Maximum Transfer Unit (MTU) of an interface.ĭstaddr addr Set the remote IP address for a point-to-point link (such as PPP). Metric N This parameter sets the interface metric. If selected, all multicast packets on the network will be received by the interface. If selected, all packets on the network will be received by the interface.Īllmulti Enable or disable all-multicast mode. Promisc Enable or disable the promiscuous mode of the interface. It is implicitly specified if an address is assigned to the interface.ĭown This flag causes the driver for this interface to be shut down.Īrp Enable or disable the use of the ARP protocol on this interface. ![]() Up This flag causes the interface to be activated. This is usually a driver name followed by a unit number, for example eth0 for the first Ethernet interface. ![]() Options interface The name of the interface. Numbers is not RFC-compliant and therefore its use is discouraged and may go away. Leading 0x or 0X implies hexadecimal otherwise, a leading '0' implies octal otherwise, the number is interpreted as decimal). All numbers supplied as parts in IPv4 dotted decimal notation may be decimal, octal, or hexadecimal, as specified in the ISO C standard (that is, a (TCP/IP, default), inet6 (IPv6), ax25 (AMPR Packet Radio), ddp (Appletalk Phase 2), ipx (Novell IPX) and netrom (AMPR Packet Currently supported address families include inet If the first argument after the interface name is recognized as the name of a supportedĪddress family, that address family is used for decoding and displaying all protocol addresses. If a single interface argument is given, itĭisplays the status of the given interface only if a single -a argument is given, it displays the status of all interfaces, even those that are down. If no arguments are given, ifconfig displays the status of the currently active interfaces. After that, it is usually only needed when debugging or when system tuning is needed. Ifconfig is used to configure the kernel-resident network interfaces. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |